SCM CUBO2 AQUA Manuel page 34

EN
Alarm Description
code
8 Motor overtemperature The temperature detected by the PTC
9 Reserved
use)
10 CPU error
11 Parameter default
12 DCbus ripple
13 Data communication
fault
14 Drive thermistor fault
15 Autotuning fault
16 Driver disabled
input open
energized)
17 Motor phase fault (**)
18 Reserved
use)
19 Speed fault
20 PFC module error
21 Power
overvoltage
22 Power
undervoltage
23 STO detection error
24 Reserved
use)
25 Ground fault
26 CPU sync error 1
27 CPU sync error 2
28 Drive overload
Pag. 32-EN
Possible cause
- wrong parameters values or inadequate
motor.
thermistor corresponds to a resistance >
2600 ohm.
(for future
Loss of data in memory
Execution of
command;
Parameters user setting corrupted
Input power supply phase loss, three-phase
power supply unbalance
Data reception failure
Internal fault
Wrong parameter values
(STO Cable disconnected
or de- Operation of external contactor
24V power supply loss
Motor cable disconnected
(for future
Wrong parameters values or unsuited load
PFC overcurrent
supply Too high power supply voltage
supply Too low power supply voltage
Internal fault
(for future
The drive has detected a ground current too
high
Overload CPU
Loss of data in memory
The current supplied has exceeded the drive
rated current over the maximum time
accepted
Solutions
Reduce the motor load.
Check motor cooling.
Call for assistance
reset parameter default Set parameters again
Check the input power supply phases to the
drive, reduce motor power (speed)
Check the serial connection. Switch the drive
off and back on again.
Call for assistance
Check the parameter values
Restart the command again
Check the wiring.
Restore external contactor
Check the connections of the motor cable
Switch the drive off and back on again and
check the parameters are properly set. Check
the motor load.
Call for assistance
Check input power supply and if inductive
load generating overvoltage are connected to
the line
Check input power supply
Call for assistance
Check ground insulation of the motor and
wires .
Call for assistance
Call for assistance
Check the load, the dimension of the motor
and the cables. Check the motor parameters.
OEM Manual – CUBO
UMT/WG T MT Rev3.0 – 08/10/2021
AQUA
2