SCM CUBO2 AQUA Manuel page 28

EN
11 List of alarms
When an alarm occurs in the controller the alarm icon in the user display will be switched ON and it will
start to blink (
To get more alarm details you should check the alarm masks available in the display.
These mask contains several information (date and time, description, suct. and disch. Pressure, codes)
that could help the user to identify the possible alarm reason and to understand which checks to
perform.
Here below some details about how to interpret the different codes shown in the alarm masks.
Highlighted in RED the main alarm reference  Check the HECU alarm table to get more details

Highlighted in BLUE the PSD (POWER+) alarm code  Check the PSD (Power+) alarm table to get

more details
Highlighted in GREEN the Envelope Zone that caused a compressor shut-off  Check the

Envelope Zone table to get more details (at page 33)
11.1 Hecu alarm
In the below table we reported a quick description about the Condensing Unit alarm with the main action
made by the controller.
The alarm Index to refer is the one reported in the alarm masks or in the alarm logs (please find an
example in the below picture. The Mask Index is the one highlighted in red).
Mask
Topic
index
ALU02
ALA01
Pag. 26-EN
).
Description
Regulation probes missing.
One of the main probe is missing or
wrong configured: P_suc, P_GC,
T_out_GC, P_receiver or
Pparallel_Suct
Discharge temperature probe
broken or disconnected.
Discharge temperature probe could
be broken, disconnected or not
properly configured
OEM Manual – CUBO
Serious Normal
Action
alarm alarm
x Shutdown Unit
No action on the regulation
The function that reduce
the compressor speed to
x prevent High Discharge
temperature will be
disabled (mask Hb02 and
Hb03)
AQUA
2
Delay Reset
No delay Automatic
No delay Automatic
UMT/WG T MT Rev3.0 – 08/10/2021