Troubleshooting; Technical Specifications - HK Audio D.A.R.T Manuel

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7 Troubleshooting

The Power switch does not light up red after you
switch the system on.
• Check if the mains cord is plugged all the way into
the Mains Input jack.
• Check if the mains power supply is actually provi-
ding current.
The Power switch lights up red, but no sound is
coming from D.A.R.T.
• Check the cables that you connected to Line In
and Mic In.
• Check if the signal sources (mixer, keyboard,
CD player) are on.
• Are the Gain Line In or Mic In knobs turned up?
The signal coming from the speaker sounds distorted.
• Check the LED displays at your mixer. They should
not be constantly in the red. If necessary, back off
the volume at the mixer.
• If the LED displays on your mixer are in the green,
turn down the Gain Line In knob on D.A.R.T.
• Observe the Limiter 1" and Limiter 12" LEDs on
D.A.R.T's control panel. These should light up red
for no more than a brief moment.
Under no circumstances may the red LEDs
illuminate continuously. If this is the case, turn
down the corresponding GAIN knob.
Annoying hum
• Check the cables that you are using to connect
the signal source to D.A.R.T If any are damaged,
replace them immediately.
• If you cannot pinpoint the cause of the hum, press
the Ground Lift switch. This should in most cases
fix the problem.
8 Technical Specifications
Frequency response +/- 3dB: 80 Hz – 19 kHz
Frequency response –10 dB: 60 Hz – 22 kHz
Axial sensitivity @1W/1m (half space): 105 dB
Maximum SPL @ 1m (half space, 10% THD): 123 dB
Loudspeakers:
Bass/mid woofer: 1x 12"
HF driver: 1" B&C
HF protection (passive): Dynamic protection circuit
Horn characteristics: 60° x 40° CD horn
Power amps:
1x 250 W Class D for bass/mid, 1x 60 W for HF
Active limiters: HK AUDIO
®
MultiBand Limiter,
Subsonic filter
Crossover frequency: 2 kHz, 24 dB/octave active
crossover
Voicing section: 2-Band EQ
Connectors:
1 XLR Line In balanced
1 XLR Through balanced
1 XLR Mic In balanced
1 RCA phono stereo In
Speaker stand mounting collar: HK AUDIO
Weight: 21 kg/ 46.2 lbs.
Dimensions (WxHxD): 56 cm x 40.5 cm x 35.5 cm /
22" x 16" x 14"
This is to certify that
HK AUDIO
complies with the provisions of the Directive of
the Council of the European Communities on the
approximation of the laws of the Member States
relating to electromagnetic compatibility
(EMC Directive 89/336/EEC) and the low voltage
Directive (73/23/EEC).
This declaration of conformity of the European
Communities is the result of an examination
carried out by the Quality Assurance Department
of STAMER GmbH in accordance with European
Standards EN 50081-1, EN 50082-1and EN
60065 for low voltage, as laid down in Article 10
of the EMC Directive.
®
DuoTilt™
Lothar Stamer Dipl.Ing.
Managing Director
St.Wendel, 04/02/02
* Stamer Musikanlagen manufactures exclusively
for HK AUDIO
®
.
9
®
D.A.R.T
Stamer Musikanlagen
GmbH*
Magdeburger Str. 8
66606 St.Wendel

Publicité

Table des Matières
loading

Table des Matières