Beem GRIND-2-GO Mode D'emploi page 23

23
1. Completely empty the collecting container (3) if necessary.
2. Remove the crank handle (6) and the lid (1) from the
grinder (2).
3. Rinse all parts with warm water. If necessary, you can use a
little mild detergent to remove more intense soiling.
4. Allow all parts to dry thoroughly before you use them again
or store them away.
Storage
•
Clean all components again before storing them away (see
the "Cleaning and Care" chapter). Once all components
have fully dried, store them in the fabric bag in a dry, clean,
frost-free place that is protected from direct sunlight and
cannot be accessed by children or animals.
Warranty and Limitations of Liability
The warranty does not cover faults caused by incorrect
handling, damage or attempted repairs. The same applies to
normal wear and tear.
We do not accept any liability for damage or consequential
damage resulting from:
•
failure to follow the operating instructions
• non-designated use
•
improper or unsuitable handling
• repairs which are not carried out properly
•
unauthorised modifi cations
EN