Beta 682/60 Notice D'utilisation Et Instructions page 26

OPERATION MANUAL AND INSTRUCTIONS
SPECIFICATIONS
Calibration range
Resolution
Display
Accuracy
Zero suppression
Units of measurement
First peak sensitivity
Auto reset hold time
Trigger from setting
Limit hysteresis
Operating temp range
Storage temp range
Max operating humidity
Power supply
Power consumption
Power cable
Power cable plug fuse (if fitted)
Case materials / finish
26
1.2 to 60 Nm (Dynatester 682/60)
8 to 400 Nm (Dynatester 682/400)
30 to 1500 Nm (Dynatester 682/1500).
5 digits.
240 x 64 pixel dot matrix display.
Update rate of three times per second
(3Hz) in 'TRACK'.
Class 1 (± 0.5% of reading) over entire
calibration range (2 – 100% of transducer
capacity).
± 1 LSD in 'TRACK' mode for Dynatester
682/60. No suppression for Dynatester
682/400 & 682/1500.
'DIAL & ELECTRONIC' and 'CLICK &
CAM' mode suppressed from 0 to
approximately 0.5% of transducer capacity.
N.m, dN.m, cN.m, lbf.ft, lbf.in, ozf.in, ft lb,
in lb, in oz, kgf.m, kgf.cm & gf.m.
Dynatester 685/60 also has gf. cm available.
2.5%(High), 5%(Med), or 10%(Low) of
reading.
1, 2, 3 or 4 seconds.
1.55% of transducer capacity.
0.5% of transducer capacity
+5°C to +40°C.
-20°C to +70°C.
85% Relative Humidity @30°C.
90 to 264 Volts a.c. at 50-60 Hz input.
9V, 300 mA D.C. output (centre positive).
2.25 W - maximum.
2 meters (6 ft 6 ins) long minimum.
1 Amp
Display and Transducer housings
engineered in aluminium castings and
finished in powder coated paint.