Beta 682/60 Notice D'utilisation Et Instructions page 16

OPERATION MANUAL AND INSTRUCTIONS
ELECTRONIC DIGITAL TORQUE METER – DYNATESTER
OPERATION MANUAL AND INSTRUCTIONS FOR ELECTRONIC DIGITAL TORQUE METER MA-
NUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The electronic digital torque meter can be used for the following purposes:
• Measuring the driving torque to check settings or calibration, torque screwdrivers and wrenches
• Right-hand and left-hand tightening.
The electronic digital torque meter must not be used for the following purposes:
• The Dynatester must not be used in humid or wet environments. Do not expose to heat, rain or snow
• The maximum capacity of the Dynatester must not be exceeded
• The Dynatester must not come into contact with chemical and corrosive substances the Dynatester
must not be used for any applications other than stated ones
WORK AREA SAFETY
Do not operate the Dynatester in environments containing potentially explosive atmospheres,
because sparks may be generated, which can ignite the dust or fumes.
Keep children away from the Dynatester.
Do not use the Dynatester near flammable material.
Do not use the Dynatester in humid or wet environments; do not expose to rain. Humid and conta-
minated environments result in an increased risk of electric shocks.
Before using the Dynatester, make sure that it has been properly fixed to a suitable structure.
See installation diagram.
DYNATESTER SAFETY
• Before use, check that the Dynatester has not been damaged, and that no parts are worn.
• Do not force the electronic circuit of the Dynatester.
16
ART. 682/60, 682/400, 682/1500
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING THE
DYNATESTER. FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND
OPERATING INSTRUCTIONS MAY RESULT IN SERIOUS INJURY.