F5 Rst; Prog" - Scale Configuration; P1 Ref" - Metric Parameters - Scale House AFW Serie Manuel Opérateur

7.6 "F4 Prt" – SETTING TOTALISATION AND TRANSMISSION MODE
TOTALIZATION AND TRANSMISSION MODE
Press TARE to select one of the suggested values:
P AUto Automatically upon weight stability.
P Prt Manually through the PRINT/M+ key.
P Cont continuous transmission with P Cont. protocol
SEr rE continuous transmission with SEr rE. protocol
ASK Transmission at request thorugh serial commands (see section 8.3)
Confirm with ZERO or press PRINT/M+ to exit without confirming.
TRANSMISSION SPEED
Press the TARE key to select one of the possible speeds : 600, 1200, 2400 4800, 9600.
Confirm with ZERO or press PRINT/M+ to exit without confirming.
TRANSMISSION PROTOCOL (only for PCONT mode)
Press the TARE key to select one of the possible protocol: Cont 1, Cont 2, Cont 3.
See section 8 for details.
Confirm with ZERO or press PRINT/M+ to exit without confirming.
PRINTER FORMAT (only for PAUTO and PPRT)
Press the TARE key to select one of the possible printing format: Lab 0, Lab 1, Lab 2, Lab 3.
See section 8 for details.
Confirm with ZERO or press PRINT/M+ to exit without confirming.
PRINTER TYPE
Press the TARE key to select one of the possible values:
tP enables the printing with ASCII printer (for example TPR).
711 Not used in this application.
LP50 Not used in this application.
Confirm with ZERO or press PRINT/M+ to exit without confirming.

7.7 "F5 rSt"

For use of the manufacturer.
7.8 "ProG" – SCALE CONFIGURATION
By pressing ZERO it's possible to access the scale configuration menu. One is asked to enter the password.
To enter the menu press the U, PRINT/M+, and TARE keys, one after the other:
The display shows the first parameter, "P1 REF".
7.8.1 "P1 REF" – METRIC PARAMETERS (*)
(*) In case of approved instrument the parameter is read only.
AZn
By pressing ZERO one sets the zero tracking, in other words, scale's thermal drift compensation parameter;
the set value corresponds to the number of divisions which is cleared.
Press TARE to select one of the suggested divisions: oFF, 0.5d, 1d, 2d, 4d.
0Auto
By pressing ZERO one sets the weight percentage for the automatic acquisition of the gross zero at start-up. If
at the start-up a weight is detected that is within the programmes percentage of the total capacity, it will be
cleared; if the weight is not within this tolerance, the display, after a few instants, shows the current weight.
Press TARE to select one of the suggested percentages: +/- 0, 2, 5, 10, and 20 % of the max. capacity.
Confirm with ZERO or press PRINT/M+ to exit without confirming.
ZERO TRACKING
AUTOMATIC ZERO AT START-UP
14