Publicité
Les langues disponibles
Les langues disponibles
Assembly: For 700-Series Jig
This section describes how to assemble the KPHA750 Pocket-Hole Jig Docking Station for use
with a Kreg 700-Series Jig.
1
Connect the Dock Adapters to the 700-Series Jig
a.
Place the 700-Series Jig on a flat surface.
b.
With one hand, lift one side of the 700-Series Jig slightly.
c.
With your other hand, place a dock adapter (D) under the jig so that the attachment pins (1)
fit into the corresponding hole on the underside of the jig; then slide the dock adapter (D)
toward the jig handle (3) to lock the dock adapter (D) into position.
One side of a dock adapter (D) has attachment pins (1) that fit under the jig; the other
Note
side has a connector (2) for a material support wing (not shown). Ensure that the wing-
connector side (2) of the dock adapter (D) extends out from the side of the jig.
d.
Repeat steps b and c to connect the other dock adapter (D) on the opposite side of the jig.
3
1
D
2
7
Publicité
