Kreg KPHA750 Manuel page 13

Operation - Using the Adjustable Stop
The adjustable stop enables you to drill pocket holes on similar workpieces at a faster pace.
The adjustable stop requires assembly. See Assembly: Adjustable Stop on page 10.
Note
1
Set Up the Adjustable Stop
If necessary, change the configuration of the adjustable stop to accommodate the size and
orientation of your workpiece in the jig:
■
Wide workpiece: If the workpiece is wide enough to extend onto the top of a material
support wing (E), use the adjustable stop (1) in its centered configuration.
■
Narrow workpiece: If the workpiece does not extend across the gap between the jig
and the material support wing (E), use the adjustable stop (1) in a side configuration.
For a side configuration, use whichever outer notch in the adjustable stop arm will be
Note
farther from the jig after you place the adjustable stop (1) onto a material support wing (E).
For instructions on changing the configuration, see Attach the Adjustable Stop Arm
Note
to the Adjustable Stop Base on page 11.
Adjustable stop (1) in centered configuration for
wide workpiece
1
E
E
Adjustable stop (1) in side configuration for
narrow workpiece
1
13