Kreg KPHA750 Manuel page 14

2
Place the Adjustable Stop in Position
a. With the adjustable stop (1) configured the way you want it, place the adjustable stop (1)
onto the lid of a material support wing (E) so that:
■
The edge of the adjustable stop arm (F) rests snugly against the workpiece.
■
The notch (2) on the underside of the adjustable stop base fits over the rail (3) that runs
across the lid of the material support wing (E).
b. Rotate the adjustable stop knob (G) clockwise until tight to secure the adjustable stop (1) in
position.
To reposition or remove the adjustable stop (1), rotate the adjustable stop knob (G)
Note
counterclockwise to loosen it. Then slide the adjustable stop (1) to a new position along the rail (3)
or lift it off of the material support wing (E).
14
E
F
G
2
3
1