Publicité
Les langues disponibles
Les langues disponibles
Removing a Kreg 700-Series Jig from an Unmounted Docking Station
a.
Detach each material support wing (E):
1.
Grasp the material support wing (E) close to where it connects to the dock
adapter (D).
2.
Gently lift up the material support wing (E) so that the material-support-wing
connector (5) pops out of the dock-adapter connector (6).
b.
Remove the dock adapter (D) from each side of the jig:
1.
Lift that side of the jig slightly off the work surface.
2.
With the jig handle (3) facing you, slide the dock adapter (D) away from you until the
dock adapter (D) disengages from the slot on the underside of the jig.
3.
Pull the dock adapter (D) out from the underside of the jig.
Care and Cleaning
Periodically clean the dock by vacuuming any chips and wood dust.
Use a damp cloth to wipe SureGrip™ anti-slip pad surfaces clean of dust and debris.
16
E
5
6
D
3
D
Publicité
