Publicité
Les langues disponibles
Les langues disponibles
Operation - Folding the Material Support Wings
You can fold the material support wings up to the vertical position to save space when the jig
is not in use, or to make it easier to move the jig from one location to another. Always fold the
material support wings down before using the jig.
To fold up the material support wings:
a.
Fold the material support wing (E) up to a vertical position.
b.
Rotate the wing lock (1) inward until the latch (2) engages in the corresponding notch:
■
For a 500-Series Jig, the notch (3) is located on the side of the dock-base back (A).
■
For a 700-Series Jig, the notch (3) is located on the side of the jig.
c.
Repeat this process for the material support wing (E) on the opposite side of the jig.
To fold down the material support wings:
a.
Rotate the wing lock (1) outward until the latch (2) disengages from the notch:
■
For a 500-Series Jig, the notch (3) is located on the side of the dock base (A).
■
For a 700-Series Jig, the notch (3) is located on the side of the jig.
b.
Fold the material support wing (E) down to a horizontal position.
c.
Repeat this process for the material support wing (E) on the opposite side of the jig.
2
3
Folding the material support wings on a 500-Series Jig
2
3
Folding the material support wings on a 700-Series Jig
12
1
1
E
2
3
3
E
2
1
1
Publicité
