Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting - Integrated Electronic Ignition
Problem (Ignition)
Possible Cause
SECTION l
No sparks appear at
Battery not installed
any electrodes when
properly.
burner control knobs
are turned to
; no
noise can be heard
Dead battery.
from spark module.
Battery cap not installed
properly.
Faulty spark module.
Switch wires
disconnected.
SECTION ll
Output lead connections
No sparks appear at
any electrodes when
not connected.
burner control knobs
Electrode tip not in
are turned to
; noise
can be heard from
proper position.
spark module.
SECTION lll
Sparks are present but
Output lead connections
not connected.
not at all electrodes
and/or not at full
strength.
Arcing to grill away from
burner(s).
Weak battery.
Electrodes are wet.
Electrodes cracked or
broken "sparks at crack".
Check Procedure
Check battery orientation.
Has battery been used
previously?
Check to ensure battery cap is
fully engaged.
If no sparks are generated with
new battery and good wire
connections, module is faulty.
Check to ensure switch wires
are connected.
Are output connections on and
Tight?
Are the electrode tips pointing
in the right direction? Is the
gap too big?
Are output connections on and
tight?
If possible, observe grill in dark
location. Operate ignition
system and look for arcing
between output wires and grill
frame.
All sparks present but weak or
at slow rate.
Has moisture accumulated on
electrode and/or in burner
ports?
Inspect electrodes for cracks.
Prevention/Solution
Install battery (make sure that "+" and "-"
connectors are oriented correctly, with "+" end up
and "-" end down.
Replace battery with new alkaline battery.
Remove battery cap and reinstall, making sure it
can be fully engaged.
Replace spark module assembly.
Reconnect switch wires.
Remove and reconnect all output connections at
module and electrodes.
Main Burners:
Tip of electrode should be pointing toward port
hole in burner. The distance should be 1/8" to
3/16". Adjust if necessary.
Sideburner:
Tip of electrode should be pointing toward gas
port opening on burner. The distance should
be 1/8" to 3/16". Adjust if necessary.
Remove and reconnect all output connections at
module and electrodes.
If sparks are observed other than from burner(s),
wire insulation may be damaged. Replace wires.
Replace battery with a new alkaline battery.
Use paper towel to remove moisture.
Replace cracked or broken electrodes.
19
Publicité
Table des Matières
