Assembly And Use Of The Processor Bowl - Ninja BL687CO Manuel Du Propriétaire

Assembly and Use of the Processor Bowl

WARNING: Chopping Blade Assembly is sharp and not locked in place. Before emptying contents carefully
remove lid and Chopping Blade Assembly, holding it by the shaft. Failure to do will result in risk of
laceration.
WARNING: Remove utensils prior to processing. Failure to remove may cause the bowl to be damaged or to
shatter, which may cause personal injury.
WARNING: Never leave the appliance unattended while in use.
CAUTION: Do not blend hot liquids, doing so may cause excessive pressure buildup, resulting in risk of the
user being burned.
CAUTION: Remove the lid from the bowl upon completion of processing. Some ingredients have the potential
to expand after blending resulting in excessive pressure buildup that can pose a risk of injury.
IMPORTANT: Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig. 1
1 Review warning and caution statements above before
proceeding to number 2.
2
Place the motor base on a clean, dry, level surface such
as a counter or table top. Press down on the motor base
to make sure that the suction cups adhere to the counter or
table top.
3
Align and lower the Processor Bowl onto the motor
base. (Fig. 1) Handle should be aligned slightly to the
right of the "LOCK" symbol on the motor base.
4
Rotate the bowl clockwise until it locks in place, you will
hear a click when the lock is engaged. (Fig. 2)
5
The bowl can be placed on the motor base two ways;
the handle can be on the front right corner or the front
left corner. (Fig. 3a, Fig. 3b)
6
Holding the desired blade assembly by the top of the
shaft, place it onto the drive gear inside the bowl.
Ensure that the blade assembly is seated properly and
is standing upright. (Fig. 4)
NOTE: The blade will fit loosely on the drive gear.
Fig. 3a
OR
Fig. 2 Fig. 3b Fig. 4
7 Add the ingredients to the bowl, making sure that they
do not exceed the highest measured marking line on
the side of the bowl.
NOTE: The 64 oz. bowl is not intended for blending
drinks. Do not overfill.
NOTE: To add liquids during blending, open the drizzle
hole on the top of the lid and pour the liquid slowly into
the mixture.
8 Holding the lid by the handle in the upright position,
place it on top of the Processor Bowl aligning the
triangle ( ) located on the lid with the triangle ( )
located on the Processor Bowl handle. (Fig. 5a) Press
the handle down until you hear a click. The triangles on
the lid and the Processor Bowl handle MUST be aligned
in order for the blender to turn on. (Fig. 5b)
9 Plug the power cord into the electrical outlet and press
the power button ( ).
IMPORTANT: As a safety feature, the power
button ( ) will flash and the motor will not work
if the bowl and lid are not installed correctly.
When the bowl and lid are installed properly, the
power button ( ) will be solid, indicating that the
appliance is ready for use.
Fig. 5b
Fig. 5a
www.ninjakitchen.com
12