Publicité
Les langues disponibles
Les langues disponibles
Hydraulic power pack with load sensing variable displacement pump and constant displacement pump
5.3
Electrical safety
12
•
Disconnect from all sources of electrical power!
–
Switch off the power supply before working on the circuit.
–
Please note that electrical energy may be stored in individual components.
Further information on this issue is available in the data sheets and operating
instructions included with the components.
Caution!
–
Capacitors inside the device may still be charged even after being disconnected
from all sources of voltage.
•
Risk of death in case of interrupted protective conductor!
–
The protective conductor (yellow-green) must not be interrupted,
either inside or outside of the hydraulic power pack.
–
The insulation of the protective conductor must never be damaged
or removed.
•
Hazard-free operation of the device is no longer possible in the case of
–
Visible damage
–
Malfunction
–
Incorrect storage
–
Incorrect transport.
–
Immediately remove the mains plug from the electric outlet.
–
Protect the device against inadvertent restart.
•
The hydraulic power pack must be switched off and its mains plug must be removed
from the electric outlet before installation, repair, maintenance and cleaning work.
•
The electric motor's ventilation slots must not be covered!
•
Set the hydraulic power pack up so that switches and interrupters are easy to
activate.
WARNING
CAUTION
© Festo Didactic 8068243
Publicité
