Problem Solving - POWIS PARKER 11 Manuel

V I P R O B L E M S O L V I N G
Symptom
Machine does not work
Can't insert binderstrip
Left Status Indicator
Light blinks red and bind
clamps re-open after
Bind button is pressed
Document not bound
Binderstrip ™ not in line
with the end of document
Binderstrip ™ only partially
bound to document, or
severely askew
Binderstrip ™ ejected from
binder and right Status
Indicator Light solid red
Right Status Indicator
Light solid red and Power the machine
Indicator Light solid red
Power Indicator Light
solid red
† Call your Key Operator.
†† If you regularly bind documents thicker than 125 sheets or longer than 11
ask your Fastback ® dealer about a Fastback
®
Fastback is a Registered Trademark of Powis Parker Inc.
© Powis Parker 1996
'
M O D E L 1 1 U S E R S M A N U A L
Possible Cause Probable Solution
No A.C. power Check power cable
• •
Fuse blown Replace fuse†
• •
Clamp not closed Press "Bind Button"
• •
Document too thick Remove some pages
• •
from document.
Bind document in two
sections††
Binderstrip ™ inserted See cleaning instructions
• •
wrong side up in Key Operator's
Manual†
Twisted or damaged strip Retry with a new Binderstrip
• •
Wrong length of Check if length of Binder-
• •
binderstrip used strip
Damaged Binderstrip ™ Retry with new Binderstrip
• •
Adhesive build up on See cleaning instructions
• •
internal strip placement in Key Operator's
guide Manual†
Adhesive on binding See cleaning instructions
• •
surfaces in Key Operator's
Damaged Binderstrip ™ Manual†
•
Binderstrip ™ fed incorrect- Check that only one
• •
or more than one Binderstrip
Binderstrips ™ were fed at one time
Binderstrip ™ jammed in See Key Operator's
• •
Manual to remove
jammed Binderstrip
Machine malfunction Turn power switch off,
• •
then on again. See detail-
ed error code explanation
in Key Operator' s Manual†
® binding machine with a larger capacity.
™
™ and document match
™
™ is being fed
™ †
3 / " (29.8 cm),
4
15