turbionaire Smart 10 Eco Mode D'emploi page 12

EN
1)
Before starting the works on systems containing flammable refrigerants, safety
checks are required to reduce the risk of fire. To repair the cooling system, the
following precautions must be observed before carrying out works on the system.
2)
The works shall be carried out in accordance with a controlled procedure so as to
minimize the risk of leakage of flammable gas or vapours during working
procedures.
3)
All maintenance personnel and the others working in adjacent places should be
trained on the nature of their work. Working in enclosed spaces should be avoided.
• Carefully store the appliance to prevent mechanical damage.
• Only the persons authorized by an accredited agency certifying their
competencies can handle refrigerants in accordance with the local
legislation.
• All repairs must be carried out in accordance with the manufacturer's
recommendations.
• Maintenance and repairs requiring the assistance of qualified personnel
must be carried out under the supervision of specialists in the use of
flammable refrigerants.
Do not perforate any of the components of the refrigerant circuit. The
•
refrigerant may be odourless.
Additional warnings for the unit using the R290 refrigerant (refer to technical
data plate for the type of refrigerant used).
FIRE HAZARD!
CAREFULLY READ THE MANUAL BEFORE USING THE APPLIANCE.
R290 refrigerant complies with the European directives regarding the protection
of the environment.
Turbionaire Smart 10 Eco contains approximately 40g of R290 refrigerant.
The unit must be installed, used and stored in a room larger than 1.90 m
Turbionaire Smart 12 Eco contains approximately 55g of R290 refrigerant.
The unit must be installed, used and stored in a room larger than 2.64 m
Instructions regarding the repairs brought to units containing R290
Checking the working area
The working procedure
The general working area
2 .
2 .