Wilson Signal Boosters Manuel D'installation page 8

In-Building
I
nstalling a Wilson Outside Antenna – In-Building
Select a location on the roof of the building to install the outside antenna that has the most
unobstructed line of sight to the cell tower .
A Yagi antenna must be installed horizontally with the elements vertical and the drip hole
on the bottom . Ensure there are three feet of clearance in all directions surrounding the
antenna .
Follow the specific antenna installation instructions included with the outside antenna.
Lightning protection is recommended for all in-building installations . Take extreme care to
ensure neither you nor the antenna come in contact with any electrical power lines .
To obtain maximum performance, the antenna should point toward the cell tower . Follow
the instructions included with the outside antenna .
Cell Tower
NOTE: See RF Safety Warnings (p. 9)
Installing a Wilson Signal Booster
Select a location to install the Signal Booster that is away from excessive heat, direct
sunlight, moisture and that has proper ventilation . Ensure the Signal Booster is installed
within six feet of where the cellular device will be used (to accommodate the six-foot
adapter extension cable) . Run the cable from the outside antenna and attach it to the
connector labeled "Outside Antenna" on the Signal Booster . Connect the power supply
(sold separately) to the power input labeled "12V DC" on the Signal Booster .
Recommended installation locations for
in-building are:
• On a wall
• On the ceiling
• Near a power outlet
7
Contact Wilson Electronics Tech Support with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
RF Signal
Yagi Outside Antenna
Hours: 7am to 6pm MST.