Before Getting Started - Wilson Signal Boosters Manuel D'installation

Before Getting Started

This guide will help you properly install Wilson's Direct Connect Signal Boosters in both
in-vehicle and in-building applications . It is important to read through all of the
installation steps for your particular application prior to installing any equipment.
Read through the instructions, visualize where all the equipment will need to be installed
and do a soft installation before mounting any equipment . If you have any questions
contact Wilson Electronics Technical Support at 866-294-1660 .
Inside this Package
• Direct connect Signal Booster
• DC plug-in power supply
• 6' inside antenna extension cable
Note: Products may vary due to product kit purchases.
Direct Connect
Signal Booster
Additional Required Equipment
• Outside antenna for in-vehicle or in-building use (required)
(NOTE: Specifically tuned iDEN antennas available)
• Cell phone or data card specific external antenna adapter (required)
• AC/DC power supply (required for in-building use)
In addition to Dual-Band cellular signal amplification, the 811201 Dual-Band Direct
Connect Signal Booster incorporates GPS signal amplification. The amplified GPS
signal enhances the performance of any GPS applications which your phone may
support, including the E911 emergency location feature if your phone is so
equipped. In emergencies, E911 enabled phones provide caller location to 911
call centers.
Contact Wilson Electronics Tech Support with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
DC plug-in power
supply
Hours: 7am to 6pm MST.
6' inside
antenna
extension
cable
2