Table des Matières
Publicité
In-Vehicle
Installing a Wilson Outside Antenna
To receive the best cell signal, select a location in the center of the vehicle's roof at least 12
inches away from any other antennas and free of obstructions .
Follow the specific antenna installation instructions included with the outside antenna (sold
separately) .
Carefully
Pull Down
Door Seal
3
Contact Wilson Electronics Tech Support with any questions at 866-294-1660
Or email: tech@wilsonelectronics.com
Optional Magnet-
Mount Antenna
Shown
Run Cable
Under
Seal
Tuck Cable
Under Seal
The outside antenna must be installed
vertically . Signal performance will be
degraded if the antenna is not vertical .
Run the antenna cable through the door to
the Signal Booster .
For a more professional looking installation,
run the antenna cable under the door seal .
Carefully pull down the door seal . Run the
cable through the seal and push the seal
back into place . This prevents constant
wear and tear on the cable as the door
opens and closes .
The antenna cable is small enough to easily
tuck under the door seal or plastic molding .
NOTE: See RF Safety Warnings (p. 9)
Hours: 7am to 6pm MST.
Publicité
Table des Matières
