Anti-Kickback Pawls And Blade Guard - ShopMaster Delta S36-290 T2 Guide D'utilisation

ANTI-KICKBACK PAWLS AND
BLADE GUARD
Riving knife (E) must be in the Through Cut position prior to
installation of the anti-kickback pawls (D) and blade guard (F)
(Fig. 9 and 10).
Insert the pawl assembly (D) into the middle slot on the riving
knife (E) as shown in (Fig. 8) while pressing the spring-loaded
pin on the right side of the pawl assembly.
Once inserted, release the spring-loaded pin so that it pops
back in to place (Fig. 9). Ensure that it is locked in place.
While holding the blade guard assembly
position, as shown in Fig. 9, pull the blade guard assembly pin
all the way up into the rear slot on the riving knife.
Rotate the blade guard assembly all the way down so that the
arms are parallel to the table (Fig. 10a). Then lock the blade
guard in place by depressing the lock tab (Fig. 10b).
Do not hold lock tab in the lock position
while installing the blade guard.
After engaging lock tab to lock blade guard in place pull up on
arms to ensure guard is properly locked.
Note: Check the blade gaurd for clearances and free
movement.
To remove the anti-kickback pawls, depress the pin and pull
the anti-kickback off the riving knife.
To remove the blade guard assembly:
1.
Lift the blade guard assembly lock lever (D) to the
unlocked position.
2.
Rotate the guard back and slide the pin (B) from the
riving knife slot.
If blade guard is not parallel to table, riving knife is not in
raised (through cut) position.
the blade guard to verify free movement of the guard system.
Be sure the guard system can be raised enough to clear your
workpiece.
Note: Blade alignment with riving knife can be adjusted. See:
Checking and Aligning Riving Knife and Saw Blade,
page 25. Check the blade guard for clearances and free
movement.
ASSEMBLY
(F) in a vertical
Raise and lower each side of
D
F
SLOT
14
PIN
E
Figure 9
ARMS
LOCK
TAB
PIN
Figure 10
Figure 10C
A
B