Publicité
Les langues disponibles
Les langues disponibles
Fax +32 030 9904733
• The appliance must not be positioned immediately under a socket.
• Do not use the appliance if the glass panel is damaged.
• Please pay attention to the aspiration and dissipation air grids, in order to avoid obstructions, fire
risks or eventual device overheating. Please do not cover the device and do not use it to dry the
linen.
• Ensure that the fan works correctly: if this is not the case, switch off the appliance and have it
checked by professionally qualified personnel.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
• All repairs should be made by a competent qualified electrician. Any faulty appliances should be
returned to this service.
Wall installation
When attaching the appliance to a wall, the wall must be made of brick and mortar and/or of material
that is heat resistant (not wood or synthetic material that heats up easily). First check whether tubes
(water and gas etc.) or electric cabling are built into the wall; thereafter follow these installation
instructions (see diagrams):
-
The appliance must be positioned so that the bottom side is away
from the floor min. 90mm÷ 100mm max from the floor.
-
use the 3 keyhole slots on the rear panel: drill three holes in the wall,
as per the distances indicated in the diagram alongside (before
drilling the holes, it is best to measure the distance between the
aforementioned slots). Insert the wall plugs into the holes and tighten
the screws so that they fit correctly through the slots
-
hang the appliance on the wall, ensuring the screws are tight enough
to support the weight of the convector heater.
Portable installation
In order to use the appliance the two feet supplied must be fitted to the same by operating as follows:
-
Always unplug the appliance before you assemble.
-
Put the appliance down horizontally on a flat, smooth surface.
-
Position the feet by inserting the hook into the slot on the side and make it run until the lower
hooks block
-
Secure their blocking using the screws supplied.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9
28
/
Assembly page 9/28
Publicité
