Publicité
Les langues disponibles
Les langues disponibles
8
CLEANING AND TROUBLESHOOTING YOUR WATERPIK
Remove
Battery
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when necessary by
using a sof cloth and mild non abrasive cleanser.
The water reservoir is removable for easy cleaning and is top rack dishwasher safe.
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of you
water. If lef unattended, it can hinder performance.
Cleaning internal parts: add 2 tablespoons of white vinegar to a full reservoir of warm
water. Point the handle and tip into sink. Turn unit ON and run until reservoir is empty.
Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Leakage
If leaking due to a damaged hose, replacement hoses and handles can be purchased at
www.waterpik.com or contact Water Pik, Inc. customer service for a self service repair kit.
Battery Removal
This product contains one coin cell battery (CR 2032) Lithium Manganese Dioxide in the
handle assembly. The battery is not replaceable. Please do not dispose of the unit in
the household waste. Remove the battery per the instructions below and recycle at your
local recycling center.
Note: This process is not reversible
Remove the battery only at the end of the product's life for recycling. Doing so earlier
will destroy the product. Observe basic safety precautions to protect your eyes, hands,
fngers, and work surface. Remove the battery as shown and recycle it and the rest of
the product according to local regulations.
1. Obtain a towel or cloth, a hammer, and a fat head screwdriver.
2. Remove and discard the tip.
3. Cover the handle entirely with the towel or cloth.
4. Clamp the top of the handle against your work surface and strike the handle
housing along the seam on the side of the handle. Pry handle apart using a fat
head screwdriver.
5. Once the handle is separated into two pieces, remove the coin cell battery from
the circuit board.
6. The internal components should slide out when the handle is positioned
upside down. If this does not occur, repeat steps 5 and 6 until the
components release.
7. Recycle and dispose of the battery properly.
8. The remaining product pieces should be discarded appropriately.
WATER FLOSSER
®
Publicité
