Waterpik WF-09 Mode D'emploi page 6

6
GETTING STARTED
Fill
Mod e
Insert
Eject
Power and
Water ON
Mode
Mod e
Low
ve
Sen siti
l C ean
Sensi tive
Clean
Mode
Mode
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be
sure it is turned on.
Preparing the Reservoir
Lif the reservoir lid, remove the reservoir, and fll with lukewarm water. Replace the
reservoir over the base and press down frmly and, close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down frmly until the
tip clicks into place. The colored ring will be fush with the top of the handle if the tip
is correctly locked into place. To remove tip from the handle push the tip eject button
on the handle.
Prime Unit (First Time Use Only)
Set pressure control dial on base to pressure setting No.10, point the handle and tip
into sink. Turn power ON and wait until water fows from the tip. Turn power OFF.
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting for frst
time use. Gradually increase pressure over time to the setting you prefer
– or as instructed by your dental professional.
Using the Water Flosser
Always place the tip in your mouth before turning the power ON.
Lean over sink and slightly close lips. Turn power ON. Allow water to fow
from your mouth into the sink.
For best results, start with back teeth and work toward the front teeth. Direct
the stream at a 90 degree angle to your gumline with tip in mouth. Glide tip along
gumline and pause briefy between teeth. Continue until you have cleaned the inside
and outside of both the upper and lower teeth.
Clean Mode
When the power is initially turned on, the Clean mode indicator light will turn on and
remain on for approximately 30 seconds before turning of.
Sensitive Mode
Designed to quickly adjust pressure for those sensitive areas of your mouth without
having to reach to the base. When sensitive mode is activated, the water fosser will
automatically reduce the pressure. For best results, use the clean mode and set the
unit to the pressure setting for you and then as you move to sensitive areas simply
hit the mode button for sensitive mode and then hit the mode button again afer you
pass the sensitive area, to go back to clean mode.