CASO DESIGN Grande Aroma 100 Mode D'emploi page 39

13.2 Assembling and disassembling of grinder and knob
Unplug the device:
Disassembling: Remove the lid of bean container. Push the button for release of knob (4)
to the side and remove it upwards. Turn the grinder anti clockwise, then take it at its
handle and pull it upwards vigorously.
Assembly: Replace the grinder and turn it clockwise until it latches. On the underside of
the knob are receptions for the pins which are located on the side of the grinder.
Push the button for release of knob (4) to the side. Replace the knob so that the squared
pin reception is placed on the squared pin (A) and the round pin receptions are placed on
the round pins (B).
► The device shows "E3". The knob is not placed correctly or the grinder is blocked. Place
knob correctly. Clean the grinder.
Warning
► The blades of the grinder are sharp, do not touch them. Be careful during
assembling/disassembling of knob for the grinder and of the grinder, and during
cleaning of the grinder.
Please note
39