Trix 22027 Mode D'emploi page 4

Safety Information
• This locomotive is only to be used with the operating system
it is designed for.
• This locomotive must not be supplied with power simultane-
ously by more than one power source.
• Please make note of the safety information in the instructions
for your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 611 655 interference
suppression set is to be used for this purpose. The interfe-
rence suppression set is not suitable for digital operation.
• WARNING! This product contains magnets. Swallowing more
than one magnet may cause death in certain circumstances.
If necessary, see a doctor immediately.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in Trix
products or where Trix products have been converted in such a way that
the non-Trix parts or the conversion were causal to the defects and / or
damage arising. The burden of presenting evidence and the burden of proof
thereof, that the installation of non-Trix parts or the conversion in or of Trix
products was not causal to the defects and / or damage arising, is borne
by the person and / or company responsible for the installation and / or
conversion, or by the customer.
4
Function
• This model is designed for operation with H0 2-rail DC sys-
tems (track according to NEM standards) with conventional
DC power packs.
• This locomotive is equipped with an Trix interface connection
for digital operation and can be retrofitted with the 66839 Trix
locomotive decoder.
• Headlights change over with the direction of travel.
The necessary maintenance that will comes due with normal
operation is described below. Please see your authorized Trix
dealer for repairs or spare parts.