Dimplex IHW 35 Instructions De Montage Et D'utilisation page 9

IHW 35, IHW 55
9. Maintenance
The unit is largely maintenance-free.
If necessary, have the dirt filter at the cold water inlet
and the jet former at the outlet of the tap cleaned by a
specialist.
10. Faults
The unit is protected against overheating by a safety
limiter. If this has been triggered, proceed as follows.
Disconnect the unit from the mains, e.g. switch off

the circuit breaker.
Connection diagram
A = cold water inlet, B = hot water outlet
www.dimplex.eu
Remove the upper part of the housing by loosen-

ing the upper screw and swinging the housing out
towards the front.
Insert screwdriver A into the opening of the shut-

off device and press the reset button. At the same
time, release the lock with screwdriver B as shown
in the picture.
Afterwards, rinse the unit thoroughly. To do this,

fully open the hot water tap for approx. 15 - 30
seconds.
Reconnect the unit to the mains.

11. Cleaning
The outer surfaces can be cleaned by wiping with a
soft, damp cloth. Do not use scouring powder or furni-
ture polish for cleaning, as these can damage the sur-
face. Do not use organic solvents.
12. Warranty
We offer a 2-year guarantee for this product in ac-
cordance with our warranty conditions.
13. Disposal
The unit must not be disposed of in general
household waste. At the end of its service
life, please take the unit to the available re-
turn and collection points.
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
D - 95326 Kulmbach
2105/A
English
Tel.: +49 9221 709 700
Fax: +49 9221 709-701
Email: info@gdhv.one
EN-5