hestan KWC Manuel D'utilisation Et D'entretien page 7

SAFETY PRECAUTIONS - BEFORE YOU BEGIN
• Do not use pointed and sharp-edged implements to remove frost or layers of ice. You could
damage the refrigerant tubes. Leaking refrigerant may cause eye injuries or ignite.
• Do not store products which contain flammable propellants (e.g. spray cans) or explosive
substances in the appliance. Explosion hazard!
• Do not stand on or lean heavily against base of appliance, drawers or doors, etc.
• Before cleaning the appliance, pull out the power cord plug or switch off the fuse. Do not
pull out the power cord plug by tugging on the power cord.
• Store high-percentage alcohol tightly closed and standing up.
• Keep plastic parts and the door seal free of oil and grease. Otherwise these parts will
become porous.
• Never cover or block the ventilation openings for the appliance.
To avoid contamination of food, please respect the following instructions:
• Opening the door for long periods can cause a significant increase of the temperature in the
compartments of the appliance.
• Clean regularly surfaces that can come in contact with food and accessible drainage systems.
• Store raw meat and fish in suitable containers in the refrigerator, so that it is not in contact
with or may drip onto other foods.
• If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry,
and leave the door open to prevent mold developing within the appliance.
INSTALLATION INSTALLATION
Make sure installation of this refrigeration appliance is performed correctly by a qualified
installer using the instructions in the Installation Manual provided with the appliance.
CONNECTION TO THE ELECTRICAL POWER SUPPLY CONNECTION TO THE ELECTRICAL POWER SUPPLY
The appliance operates at 115 VAC, 60 Hz and is equipped with a
power supply cord with a 3-prong grounded plug, which must be
connected to a corresponding 3-prong (15 Amp) grounding-type wall
receptacle.
A circuit breaker or suitable fuse should be easily accessible so that
it can be easily switched off before performing any installation or
maintenance.
• DO NOT ground to a gas pipe.
• DO NOT have a fuse in the NEUTRAL or GROUNDING circuit. A
fuse in the NEUTRAL or GROUNDING circuit could result in an
electrical shock.
• Do not use extension cords and/or multiple adapters for the power supply
connection.
(CONT.)
©2021 Hestan Commercial Corporation
EN
5