Sebson BWM OUTD W Mode D'emploi page 6

Adresse:
SEBSON
Sebastian Sonntag
Gernotstr.17
44319 Dortmund
Germany
Mail: support@sebson.de
UST-IDNr.:DE246981805
WEEE-Reg.-Nr. DE 78960174
Manual
Thank you for choosing a product of SEBSON. Please read the instructions carefully and keep them for looking up
before start-up this product. A long and failure-free operation can only be guaranteed if the installation and start-up
is done properly. Before starting up this product, please check for external damage. In case of visible external
damage we immediately dis-advise the start-up of this product! Please remove all packaging material of this product
before the first start-up an and check the content for completeness!
Intended use:
This motion detector by SEBSON detects heat radiation from moving objects with the help of the integrated infrared
motion detector. When movement is detected, the integrated LED light switches on.
Scope of delivery:

BWM_OUTD_W
General safety information:
Danger of suffocation:
parts that can be swallowed!

The remodeling of this product is not allowed! The proper and safe functioning of the device can no longer
be guaranteed if it is modified! In addition, this will invalidate the warranty claim!

The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!

Any other use than the description may result in damage to the product. So the dangers are such as
electric shock, short circuit, fire etc.

We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.

This product is suited for indoor- and outdoor-use.

Protect the product from external damage, heavy dirt, moisture and excessive heat!

In order that the warranty claim does not expire please use only the supplied items. Repairs may only be
done by an expert and only by using original spare parts!

In commercial institutions, the accident prevention regulations of the professional trade association for
electrical equipment and facilities must be adhered to.
Inserting or changing the batterie (Fig.2):

Open the battery compartment on the back.

Insert 4 batteries type: AAA 1,5V into the battery compartment. Note: Make sure that the polarity is correct
when inserting the batteries!

Close the battery compartment again after inserting the battery. Make sure that the battery compartment is
always closed! Do not use the device if the cover of the battery compartment is damaged or missing!
 Note the general information about using batteries (see "General instructions for using batteries").
Please keep this product away from children and animals. The packaging contains small
6