shark APEX DuoClean AZ1000 Serie Guide Du Propriétaire page 6

MAINTENANCE
NOZZLE MAINTENANCE
THE SELF-CLEANING BRUSHROLL
If any hair is wrapped around the brushroll, continue vacuuming, using Carpet/Low Pile mode
on a bare floor surface, a low-pile carpet, or a small area rug. This will allow the self-cleaning
brushroll to remove the hair wrap and send it to the dust cup.
If you run over a hard or sharp object or notice a noise change while vacuuming, check for
blockages or objects caught in the brushroll.
If some fibers remain wrapped around the brushroll after continued use, open the brushroll
garage to remove them.
1 To open the brushroll garage, slide both release buttons on the floor nozzle away from you,
toward the back of the nozzle, then lift off the lid.
2 Clear away any objects or debris.
3 To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then
push down on both sides of lid until it clicks securely into place. If Brushroll Indicator Light is
green and headlights are flashing, check again that both sides of lid are locked in place.
CLEANING THE BRUSHROLL
To open the brushroll garage, slide both release buttons toward the back of the nozzle, then lift off
the lid. Clear away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of the lid into the 3 slots in the nozzle, then
push down on both sides of the lid until it clicks securely into place.
CLEANING THE SOFT ROLLER
First, remove the brushroll garage lid. To
remove the Soft Roller from the nozzle, lift it
out by the pull tab. Tap loose debris off the Soft
Roller. Use a dry towel to wipe the Soft Roller
clean, or to remove any debris caught in the
teeth behind the Soft Roller.
s h a r kc l e a n . c o m
Hand wash the Soft Roller as needed. Use only
water, and allow it to air-dry completely for
at least 24 hours. Reinsert the Soft Roller in
the front of the nozzle until it clicks into place.
Reinstall the brushroll garage lid.
CHECKING FOR BLOCKAGES
Detach hose from vacuum pod, and check
hose and opening on back of pod for
blockages.
Detach wand from floor nozzle, tilt nozzle
neck back, and check opening for blockages.
Detach wand from floor nozzle and handle,
and check both ends for blockages.
Detach handle from wand and hose from
the vacuum pod, and check openings for
blockages.
s h a r kc l e a n . c o m