AEG 68001K Instructions De Montage Et Mode D'emploi page 23

Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds
Display is switching be-
tween two heat settings
f
flashes
_
is lit
e
and number are dis-
played
If you are unable to remedy the problem by following the above
suggestions, please contact your dealer or the Customer Care De-
partment.
1
Warning! Repairs to the appliance are only to be carried out by quali-
fied service engineers. Considerable danger to the user may result from
improper repairs.
3
If the appliance has been wrongly operated, the visit from the customer
service technician or dealer may not take place free of charge, even
during the warranty period.
All manuals and user guides at all-guides.com
The On/Off sensor field has
been covered up, e.g. by a
cloth
Power management is re-
ducing the power of this
cooking zone
Unsuitable cookware
No cookware on the cook-
ing zone
The diameter of the bot-
tom of the cookware is too
small for the cooking zone
Overheating protection for
the cooking zone has been
triggered
Electronics fault
Do not place any objects
on the control panel
See the section "Switching
the power function on and
off"
Use suitable cookware
Place cookware on the
cooking zone
Move onto a smaller cook-
ing zone
Use suitable cookware
Switch off the cooking
zone. Switch the cooking
zone on again
Disconnect the appliance
from the electrical supply
for a few minutes (Take the
fuse out of the house's
wiring system)
If after switching on again,
e
is displayed again, call
the customer service de-
partment
23