Operation - Klarstein TURBOHYBRID Mode D'emploi

EN
18
Notice About Discharging
The light keep blinking if the battery is with full electricity, when the battery is
discharged, the lights will turn off gradually till last one light extinguished.
Note: During discharging process, If the battery surface temperature exceeds 70 ,
the light will keep blinking for 5 seconds, afterwards, the battery will enter into
self-protection procedure, battery will cut off the electricity to main vacuum cleaner.
When the battery surface temperature goes back to 65 , the battery could work
again.

OPERATION

• Once your appliance is fully charged. Remove it from the base, hold it by it's
handle.
• Switch it on by pressing Switch button on handle or handy vac for cleaning job.
• After complete the cleaning job, press the switch button on handle or handy vac to
switch off the appliance, before putting it back into the charging base.
Note: there are two working speed for this appliance, after first switch on, it will run
at low speed. After twice pressing the switch button, the appliance will run at high
speed.
Using the acessories
• Use the motorized brush to clean floors and carpets.
• There are crevice nozzle and small brush as accessories at the backside of handle
part, install the nozzle firstly, then install the small brush into crevice nozzle as
below picture for cleaning narrow, hard to reach places etcs.
• You should regularly check that brush and accessories are cleaning after next time
using.