Publicité
Les langues disponibles
Les langues disponibles
Fax +32 030 9904733
5)
To turn off the fan heater, completely turn off the heating element (1000W switches); let the fan
run for about 3 minutes to cool the heating element (and extend its life), then turn off the fan
with the 0/I switch.
6)
If the heater will be unused for long periods of time, remove the plug from the outlet.
7)
In the case that the heater is accidentally knocked over, the safety switch in the base will turn off
the device: reposition the fan heater and it will resume normal operation.
mod.S226 (PTC fan heater with electronic display + remote control)
The appliance is equipped with controls for start-up, power adjustment, (1000W "LOW" and 2000W
"HIGH"), room temperature (15°-30°C) "AUTO", and oscillation "
alternately to right and left); these functions are controlled by pressing the buttons on the control
panel or the remote control. The remote control must be directed towards the display next to the
switches, after having inserted the batteries required (open the rear slot cover and insert 2 "AAA"
type batteries, taking care to respect the correct polarity. Close the slot cover again).
The fan heater instructions are as follows:
1) Insert the plug in the wall socket: the led above the control panel will light up to show that the
heater is connected to the main line.
2) Turn the "
" switch (on the panel or the remote control), to start up the fan.
3) Select the required function, by pressing the "
control); each time the button is pressed the display will light up the required function (FAN-
LOW-HIGH-AUTO) and show the current room temperature. (room temp).
4) The room temperature can be adjusted between 15° and 30°C by using the (AUTO) function; (
to increase the desired temperature and the (
5) To obtain the oscillation function, press the "
Timer: this function allows setting the operating time and the fan will automatically stop at the end.
To set the operating time, repeatedly press the "
every time the key is pressed, the time set is changed and the indicator light on the control panel lights
corresponding to the time selected (1 hour, 2 hours, 4 hours): the maximum time is 8 hours.
To deactivate the time, set the maximum time and then press "
indicators go off).
6) When switching off the appliance, leave the fan (FAN) running for about 3 minutes after heating
switch-off to cool down the heat element (this will provide longer element life), and then switch off
the appliance completely using the "
7) When the appliance is not in use for long periods, remove the plug from the wall socket.
8) If the fan heater is hit accidentally causing it to fall over, the safety switch on the appliance base
will switch off the heater automatically: by replacing the heater in its correct position it will
automatically begin normal function again.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
" button several times (on the panel or the remote
) to decrease the desired temperature.
" button (on the panel or the remote control).
" key on the remote control or the control panel:
" switch (on the panel or the remote control).
8
20
/
Assembly page 8/20
" (about 90° rotation,
" again (the corresponding
)
Publicité
