Screen Brightness; Standby Settings; Advanced Settings; Ch Settings - Ariston NIMBUS M NET Mode D'emploi Pour L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.10.4

Screen brightness

From this menu you can change the brightness of the display.
– Press the selector
– Turn the selector
display when it is in active mode (from 10% to 100%).
– Press the selector
3.10.5

Standby settings

Standby settings
Brightness in standby
Standby timing
Screen saver selection
– "Brightness in standby": allows to set the brightness
of the display when the device is in stand-by mode
(from 10% to 30%).
– "Standby timing": allows to set the time interval (from
1 to 10 minutes) from the last operation made on the
device, after which the screen enters stand-by mode
and its brightness is reduced to the value set for the
stand-by mode.
– "Screen saver selection": allows to select the type of
screen to be displayed in stand-by mode.
Standby settings
Brightness in standby
Standby timing
Screen saver selection
– "OFF": displays the selected home page.
– "Room T": displays the current room temperature.
to enter the edit mode.
to adjust the brightness of the
to confirm.
70%
1 min
Room T
Fig. 59
OFF
70%
Room T
1 min
Room T
Fig. 60

3.11 Advanced settings

3.11.1

CH settings

Advanced settings
CH settings
Cooling settings
AUTO function
Buffer
Heat Pump
System measurement unit
– "CH setpoint temperature": in the menu you can set
the water temperature set-point in heating mode for
each hydraulic zone present in the system. The menu
can be used to:
– adjust the temperature set-point if the automatic
temperature control function ("AUTO function") is
disabled.
– apply a correction to the temperature set-point
using a slider, if the automatic temperature control
function ("AUTO function") is active and the
water temperature does not match the desired
temperature.
T set Z1
-
Push Ok to confirm
User menu
>
>
ON
>
>
International
system
Fig. 61
0°C
+
Fig. 62
23 / EN

Publicité

Chapitres

Table des Matières
loading

Table des Matières