Operating Mode; Zone Name; Room T Setpoint; Time Program - Ariston NIMBUS M NET Mode D'emploi Pour L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.1.1

Operating mode

Allows for selecting the zone's operating mode.
– "OFF": the zone is in anti-freeze protection mode. The
room protection temperature is set to 5°C by default.
– "Manual": the set-point temperature is maintained for
24 hours.
– "Time Program": the room temperature of the zone
follows the time schedule profile for the zone.
3.1.2

Zone name

Through this field you can assign a name to the zone from a
list of pre-set values. (Note: the function is only available if the
interface is connected to configured products).
3.1.3

Room T setpoint

In manual mode you can set the temperature of the zone.
3.1.4

Time Program

Quick access to the time scheduling of the zone (visible only in
the Programmed operating mode).
3.2

Time scheduling

3.2.1

Heating/Cooling time scheduling - 2 levels

The time scheduling allows the user to heat the room based on
personal preferences.
Two-level time scheduling can be selected under "Advanced
settings" in the user menu or from the 0.4.3 parameter of the
technical menu.
Select the desired operating mode.
Time program
Heating
Cooling
DHW
Auxiliary
Buffer
The time scheduling can be defined in the same way for both
the heating and cooling profiles.
The heating and cooling modes have dedicated set-points in
their respective schedules.
Zone selection
Select and confirm the zone for time scheduling.
Zone 1
SET
20°
,5
Zone 4
20°
SET
,5
Defining the comfort and reduced set-point temperatures
Zone 1
Set comfort temperature
Set reduced temperature
Set time program
– Turn the selector
temperature" or "Set reduced temperature".
– Press the selector
selector
>
– Press the selector
>
– The "Set time program" allows the user to define the day
>
of the week to be scheduled.
>
>
Fig. 20
Zone 2
SET
21°
20°
21°
20°
,5
,5
,5
Zone 5
21°
20°
SET
21°
20°
,5
,5
,5
to highlight either "Set comfort
to enter the edit mode. Turn the
to define the temperature set-point.
to confirm the value.
13 / EN
User menu
Zone 3
SET
21°
,5
,5
Zone 6
SET
21°
,5
,5
Fig. 21
20,0°C
16,0°C
>
Fig. 22

Publicité

Chapitres

Table des Matières
loading

Table des Matières