Publicité
Les langues disponibles
Les langues disponibles
⇒ The SWAP command swaps the contents in two memory variables.
Relational Operators
The relational operators that can be used in FOR loops and conditional
branching are:
= = (equal to), < (less than), > (greater than), ≠ (not equal to), ≤ (less
than or equal to), ≥ (greater than or equal to).
Creating a New Program
1.
Select NEW from the program menu and press [
2.
Select the calculation mode you want the program to run in and press
[
].
3.
Select one of the ten program areas (P0123456789) and press [
4.
Enter your program's commands.
• You can enter the calculator's regular functions as commands.
• To enter a program control instruction, press [ 2nd ] [ INST ] and
make your selection.
• To enter a space, press [ ALPHA ] [ SPC ].
5.
A semicolon (;) indicates the end of a command. To enter more than
one command on a command line, separate them with a semicolon. For
example:
INPUT
Line 1:
You can also place each command or group of commands on a
separate line, as follows. In this case, a trailing semicolon can be
omitted.
INPUT
Line 1:
PRINT
Line 2:
Executing a Program
1.
When you finish entering or editing a program, press [
to the program menu, select RUN and press [
[ PROG ] in MAIN mode.)
2.
Select the relevant program area and press [
the program.
3.
To re-execute the program, press [
result is on the display.
4.
To abort the execution of a program, press [
appears asking you to confirm that you want to stop the execution.
STOP : N Y
Press [
] to move the cursor to Y and then press [
A ; C = 0.5
A ;
×
A ; C = 0.5
A [
×
" C = " , C ; END
PRINT
" C = " , C ;
]
] while the program's final
CL
/
E-29
].
END
/
] to return
CL
ESC
]. (Or you can press
] to begin executing
]. A message
ESC
].
].
Publicité
