Klarstein ICEWIND Mode D'emploi page 17

Clean the air filter screen
(map 1)
• Cut off the power supply, pull the handle of air filter screen, remove it from
appliance.
• Clean the air fliter screen with neutral detergent and banister brush, then clean it
with clear water.
• Finally, reinstall to the appliance.
Clean the wetted pad
(map 2)
• Cut off the power supply, take down the air filter screen, then draw the wetted pad
from support.
• Clean the wetted pad with neutral detergent and banister brush, then clean it with
clear water.
• Finally, reinstall to the appliance.
Note: The wetted pad must be installed horizontally, in order to aviod leaking.
Clean the water tank
(map 3)
• Cut off the power supply.
• Take out half of the water tank, clean it with neutral detergent, and wash it with
clear water.
• Then reinstall to the appliance.
Clean the shell
• Cut off the power supply when clean the appliance, as there have a high pressure
in the body.
• Clean with neutral detergent and soft cloth.
Note: Do not leave any water on the surface of control panel.
EN
17