Care And Maintenance; Troubleshooting - Allen + Roth L1120H Instructions

CARE AND MAINTENANCE

IMPORTANT: Shut off the main power supply before beginning any maintenance. Do not use
water or a damp cloth to clean the ceiling fan.
• Clean fan housing with only a soft brush or lint-free cloth to avoid scratching the finish. Clean
blades with a lint-free cloth.
• This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit
situation. If the fuse blows, unplug the product from the outlet and replace the fuse as below:
1) Grab the plug and remove it from the receptacle or other outlet device. Do not unplug by pulling
on cord.
2) Slide open fuse access cover on top of attachment plug toward blades.
3) Remove the fuse carefully.
4) Replace fuse.
CAUTION: Risk of fire. Use only 5-amp, 125-volt fuses.
5) Slide closed the fuse access cover on top of attachment plug.
CAUTION: Risk of fire. Do NOT replace the attachment plug, as it contains a safety device
(fuse) that should not be removed. Discard the product if the attachment plug is damaged.

TROUBLESHOOTING

PROBLEM
1. Fan does not
move
2. Noisy operation
3. Excessive
wobbling
POSSIBLE CAUSE
1. Power is off or fuse is blown.
2. Bad wire connection.
1. Blades are loose.
2. Blade is cracked.
3. Non-approved speed control.
1. Unbalanced blades.
2. Blades are loose.
3. Fan not securely mounted.
4. Fan too close to vaulted ceiling.
CORRECTIVE ACTION
1. Turn power on or check fuse.
2. Turn power off. Loosen canopy,
check all connections.
1. Tighten all blade screws.
2. Replace blades (call customer
service for special replacement).
3. Replace with an approved speed
control device.
1. Switch with blade from opposite
side.
2. Tighten all blade screws.
3. Turn off power. Carefully loosen
canopy, and remount securely.
4. Lower or move fan. Extension
downrods may be offered (call
customer service).
8
allenandroth.com
TM