EINHELL DKS 405/1 E Mode D'emploi page 14

Anleitung DKS 405-1 E_SPK1:_
GB
OUTLET BEFORE YOU REMOVE OR CHANGE
THE BLADE.
2. To carry out internal cuts in a panel: Remove the
blade as described in Section 7.2
3. Drill a 6.3 mm hole in the panel.
4. Place the panel on the saw table with the drilled
hole above the access hole.
5. Install the blade through the hole in the panel and
adjust the blade tension.
6. When you have completed the internal cuts,
remove the blade from the blade holders (as
described in Section 7.2) and take the panel off
the table.
8.5. Adapter for jigsaw blades (Fig. 8/9)
Remove the saw blade as described in 7.2.
Now insert the fretsaw blade (a) in the adapter.
First remove the table insert (18).
Then hook both adapters (22) on the two saw
blade holders (8/13).
Insert the saw blade as described in 7.2.
9. Maintenance
Bearings
Lubricate the bearings of the guide rollers
periodically with high-grade machine grease, but at
least after every 25-30 hours in operation.
Cleaning
Sawdust should be removed from the inside of the
fretsaw at regular intervals. Switch off the machine
and pull out the power plug before you open the left
cover (4). You can then use a brush or vacuum
cleaner to clean the inside. Sawdust and chips have
to be removed from the motorʼs air vents after every
work session.
Maintenance
Do not carry out any repairs yourself. If any problems
arise, take your fretsaw to a specialist workshop.
10. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
14
23.11.2006 11:13 Uhr Seite 14