Cabling; Functioning Of Slimstone - Locinox SlimStone Manuel

4.

CABLING

The SlimStone is equipped with a 7 conductor
cable which is 2m long.
EN
See p. 55 for a detailed connection scheme.
Power supply
A  AC1
B  AC2
Relay
C  Relais COM
D
 Relais NC
E
 Relais NO
Override button
F  NO button
G  COM button
Unused cable ends must be insulated
separately to ensure a proper functioning
of the keypad.
5.

FUNCTIONING OF SLIMSTONE

5.1 ENTER A CORRECT CODE
• Enter a personal code (min. 4 - max. 8
digits).
• Press # to confirm the code.
• A light sequence runs from the bottom to the
top during the time the relay is energised
(default time = 8 seconds).
10
AC-TRANS12V/25W
12V 220V
+12V
A
0
B
C
D
E
F
G
 Blue
 Brown
 Black
 Red
 Orange
 White
 Green
N
L1
220V
• If the sequence light stops, the relay is no
longer energised. The SlimStone is ready for
a new code.
5.2 ENTER A WRONG CODE
• Enter a wrong code.
• Press # to confirm the code
• All lights flash for 2 seconds, indicating a
wrong code has been entered.
• If 5 or more wrong codes are entered
consecutively, you won't be able to use the
SlimStone for a certain period due to safety
reasons. The time out period is specified as
follows :
[number of failed attempts]
2
For example : 6 failed attempts result in a
time out period of 64 seconds (2
The time out period is reset when a correct
code is entered, or if no new code was
entered during 2 hours.
5.3 PRIORITY CONTACT
• An external button or actuator can be
connected to overrule the SlimStone. For
example an intercom, free exit, ...
• Connect the wires F & G according to the
connection scheme on p55.
• The NO-contact of an external push-button
should be connected between the "NO
Button" (F) and the "COM button" (G).
Attention! This must be a dry contact with
NO function.
• The light sequence is running from bottom to
top during the time the relay is energized.
seconds.
seconds).
6
SlimStone