Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS
Cup Warming Drawer
FLUSH INSET INSTALLATION
ANTI-TIP BLOCK
146 mm
FLUSH INSET HEIGHT
SIDE VIEW
*Will be visible and should be finished to match cabinetry.
NOTE: Dashed line represents profile of unit.
|
4
English
597 mm
FLUSH
INSET
25 mm
DEPTH
FINISHED
CLEATS*
TOP VIEW
3 mm
21
E
3 mm
mm
603 mm
FLUSH INSET WIDTH
FRONT VIEW
INSTALLATION
Preparation
Remove and recycle packing materials. Do not discard the
package containing two screws provided for installation.
If the cup warming drawer is installed independently, install
an anti-tip block against the rear cabinet wall. Verify screws
are adequately secured and do not penetrate electrical
wiring or plumbing.
Installation
Turn power off to the electrical outlet.
1
Slide the left corner of the cup warming drawer into the
2
opening. If the electrical supply is located in the opening,
plug the power cord into the receptacle. If it is located in
an adjacent cabinet, guide the power cord through the
hole in the cabinet wall. Coil excess power cord behind
or beside the unit.
Slide the unit back into the opening until the trim
3
meets the cabinet front. Avoid pinching the power cord
between the unit and cabinet wall.
Open the cup warming drawer to full extension. Drill a
4
pilot hole in each mounting hole, located at the front, on
each side of the unit. Refer to the illustration below.
Mount the unit using two screws provided.
5
Turn power back on to the electrical outlet.
6
MOUNTING
HOLE
Mounting hole.
Publicité
