Chicco KIROS I-SIZE Mode D'emploi page 11

R129, for use in vehicles with "i-Size compat-
ible" seats as indicated by the car manufac-
turer in the car instruction manual and the
attached vehicle compatibility list. In case of
doubt, please contact the child car seat man-
ufacturer or dealer.
• WARNING! Serious Danger! Do not install
the child car seat on seats where the airbag
is activated.
1.2 DESCRIPTION OF THE COMPONENTS
i-Size base
Fig. C
A. Isofix connectors
B. Isofix connector removal lever
C. Isofix system connection indicators
D. Isofix connector release buttons
E. Child car seat fastening slots
F. Child car seat correct fastening indicator
G. Support leg
H. Support leg height adjustment button
I. Leg support correct installation indicator
J. Rebound bar
1.3 INSTALLATION AND REMOVAL OF THE
I-SIZE BASE
Proceed as indicated to install the i-Size base:
- Remove the plastic cover from the Support
Leg (Fig. 1).
- Extract the Support Leg (G) (Fig. 1A). An
acoustic signal will activate and stop when
the i-Size base has been installed correctly.
- Completely extract both Isofix connectors
(A) of the base by pulling the connector ex-
traction lever (B) (Fig. 2). Make sure that the
system is extracted to the end stop.
- Position the i-Size base on desired seat and
fasten the Isofix connectors to the anchor-
age points found between the backrest and
the vehicle seat (Fig. 3). You will hear a "click"
when the connectors fit into place.
WARNING! Make sure that the connection
was made correctly by checking that the two
indicators (C) are green.
- Push the i-Size base firmly against the back-
rest of the vehicle seat (Fig. 4) to make sure it
is securely in place.
- Check that the two connectors are fastened
correctly by trying to pull the base multiple
times.
- Position the Support Leg (G) and adjust it
using the adjustment button (H) (Fig. 5).
When the support leg is installed correctly,
the acoustic signal will stop and at the same
time, the indicator (I) will turn green (Fig. 6).
REMOVAL
Press the support leg adjustment button (H)
and shorten it to the end stop. Lift the ISOFIX
connector extraction lever (B) and move the
base away from the backrest to the end stop.
Release the ISOFIX connectors by pushing the
release buttons (D) (Fig. 7).
Hold down the ISOFIX connector extraction
lever (B), push the ISOFIX base into the base,
making sure to reach the end stop. Turn the
support leg and fasten the feet in the provided
slot, deactivating the acoustic signal.
WARNINGS ELECTRICAL PARTS
• To replace the battery: loosen the screw lo-
cated on the foot of the support leg (Fig. 8),
open the cover (Fig. 9), remove the drained
battery from the compartment, insert the
new battery, making sure that the correct
battery polarity is observed (positive pole
facing upwards) (Fig. 10), refit the cover and
tighten the screw fully.
• Batteries must only be replaced by an adult.
• Use a 3V, CR 2032 battery similar to the type rec-
ommended for the operation of this product.
• Always keep batteries and tools out of reach
of children.
• Always remove flat batteries from the prod-
uct to prevent any possible liquid leaks from
damaging it.
• Do not throw dead batteries into a fire or
leave them in the environment; they must be
disposed of through waste sorting.
• If the batteries are leaking liquid, replace
them immediately, making sure to clean the
battery compartment; thoroughly wash your
hands if they have come into contact with
the liquid.
• Always dispose of leaking batteries immedi-
ately: they can cause burns or other types of
injuries.
• Prevent the electric part from coming into
11