Kimberly-Clark PROFESSIONAL ICON Automatic Mode D'emploi page 6

Carriage Bolt Method
5. Install the carriage bolt and
angle bracket that works best
for the install at the bottom of
the dispenser where there are
holes for the carriage bolts and
angle brackets to be installed.
6. Check the level once again and
ensure the system is secure.
Strapping Method
1. Find the hex head screws
used to secure the folded
towel system to the wall and
remove them. Typically, there
are 4 screws, two on the back
housing at the top and two on
the bottom. We have found
that it is easiest to use pliers to
remove the hex head screws.
2. After all the screws are
removed, grasp the towel
system where the folded towels
would exit the dispenser and,
on the door, and pull and twist
until the system pops out of
the housing.
3. Once the folded towel
dispenser is removed, note
that there is no backing where
the new dispenser will be
installed. If installed in an air
shaft, the opening will need
to be covered. This can be
completed by cutting the box
that the new dispenser came
in to cover the hole or use
another suitable material to
cover the open area.
5.
1.
3.
6.
2.