Publicité
Les langues disponibles
Les langues disponibles
Dispenser Removal
9. If present, remove and discard
the black folded towel holder.
10. Take the housing frame to
be installed and turn it over.
Using the alcohol pads, clean
the bottom corners and allow
to air dry for 15 minutes. Then
place the VHB tape on each
bottom corner. Note: one or
two strips will be needed.
Leave the cover on the top
piece of tape.
There are two methods if installation that can be used for this dispenser, the carriage bolt
method and the strapping method. The Carriage Bolt Method and Strapping Method are
detailed in the following sections.
Carriage Bolt Method
1. Remove door and housing if
possible. Circumstances may
vary based on model.
2. Take the carriage bolts and the
angle brackets that came with
the dispenser and determine
whether the longer or the
shorter one is needed for the
install.
3. Carefully remove the cover on
the tape on back of housing.
4. Install the dispenser housing
in the area where the folded
towel dispenser was located.
This dispenser has a lip on top
and it is important to place the
lip over the top of the housing
still left in the wall as shown.
9.
1.
3.
10.
2.
or
4.
Publicité
