Table des Matières
Publicité
INSTALLATION Continued
Parts List
ITEM #
1
2
3
4
5
6
7
8
9
10
5. Attach each leg (1) with three 3/8" bolts and flat washers.
6. Mount right and left open stand rack support (6) to the
front and rear legs using #10 Phillips head sheet metal
screws.
7. Mount the four rack clips (9) to the upper rack supports
(6) with 10-24 bolts, nuts and lock washers. If the holes at
the edge of the rack clip (9) are used it will accommodate
18" x 26" pans, if the holes in the center of the rack clip (9)
are used it will accommodate oven racks.
8. Mount the open stand lower rack support (8) to the legs
using #10 Phillips head sheet metal screws.
9. Place the rack guides (7) on the rack clips (9). Attach the
bottom of each rack guide (7) to the lower rack support
(8) with two rack clips (10) with 10-24 nuts, bolts and lock
washers.
10. Make sure all bolts and screws are tight.
11. Stand the unit up.
12. Move the unit into its desired location.
Part # 4520415 (07/12/11)
QTY
4
Legs
4
Square Foot Inserts (Foot Version Only)
2
Heavy Duty Casters W/O Brakes (Caster Version Only)
2
Heavy Duty Casters W/Brakes (Caster Version Only)
4
Caster Pad Assembly (Caster Version Only)
2
Open Stand Upper Support (Open Base Versions Only)
2
Rack Guides (Open Base Version Only)
1
Open Stand Lower Rack Support
4
Rack Support Clips (Top)
4
Rack Support Clips (Bottom)
1
Bag of Hardware
12
3/8"-16 x 3/4" Bolts
12
3/8" Flat Washers
16
10-24 x 3/4" Hex Head Machine Screws
16
# 10 Split Ring Lock Washers
16
# 10-24 Hex Nuts
28
# 10 x 3/4" Truss Heat Sheet Metal Screws
DESCRIPTION
13. Level the oven using a 1" wrench to adjust the feet or the
casters.
Assembly Instructions for Legs
1. Raise the unit or lay on its left side.
2. For foot versions take a hammer and lightly tap a square
foot insert (2) into each leg.
3. For caster versions attach a caster pad assembly (5) to the
bottom of each leg. Position caster pad (5) and drill four
11/64" diameter holes in the leg and fasten the caster pad
to the leg with #10 Phillips head sheet metal screws.
4. For caster versions screw the heavy duty casters with
brakes (4) into the front legs and the heavy duty casters
without brakes (3) into the rear legs, ( single deck only).
5. Attach each leg (1) with three 3/8" bolts and flat washers.
6. Make sure all bolts and screws are tight.
7. Stand the unit up.
8. Move the unit to desired location.
Page 7
Publicité
Table des Matières
