Using The Remote Control; Remote Control; Basic Operations; Connect The Toshiba Projector - Toshiba TLPC001 Manuel De L'utilisateur

Using the remote control

Point toward the IR sensor located at the front panel of TLPC001 to
operate the unit with the remote. The approximate distance is about 5m.

♦ Remote control

The remote control may fail to operate if the IR sensor is
•
exposed to bright sunlight or fluorescent lighting.
Do not drop or bang the remote control.
•
Do not leave in hot or humid locations.
•
Do not get wet or place on top of wet objects.
•
Do not take apart.
•
In rare cases, ambient conditions could impede the operation of
•
the remote control. If this happens, point the remote control at
the main unit again, and repeat the operation.
19

Basic operations

1. Connect the Toshiba projector

Connect the TLPC001 document camera to Toshiba projector by
following the instruction in "Connecting a Toshiba projector".

2. Connect a computer.

Connect the TLPC001 document camera to a computer by
following the instruction in "Connecting a computer".

3. Turn on the power.

The sequence at the time when the power is supplied
(1) Upon connecting the power source, the unit
automatically warms up for about 15~20 sec. During
this time, the ON/STANDBY LED is blinking. Only
LED lighting switch and flicker switcher (50/60Hz)
can be operated.
(2) When the ON/STANDBY LED turns steady orange,
the TLPC001 document camera is now in standby
mode. You may now press the ON/STANDBY
button to start the operation.
(3) When the ON/STANDBY LED turns steady green,
you may now see the signal from the TLPC001
document camera on the screen. The CAMERA
LED is now on. To view the signal from the
computer, press INPUT button.
(4) When the ON/STANDBY button is pressed for the
second time, TLPC001 document camera switches
to standby mode and the ON/STANDBY LED turns
steady orange. You will no longer see the TLPC001
document camera signal on the screen.

4. Adjust the camera

Turn on the LED light and then position the TLPC001 camera
head by adjusting the gooseneck and arm in any angle.
20