Control Panel And Remote Control; Zoom Operation; Led Indicator - Toshiba TLPC001 Manuel De L'utilisateur

Control panel and remote control

(1) (4)
(5)
(2)
(3)
(6)
Control Panel
Name Function
Control panel
(1) ON/STANDBY : Turn the unit on/standby
(2) INPUT : Switch to output signal from TLPC001
document camera or computer in
(3) GAIN : Adjust the gain value of the image (±16)
(4) ▲, ►, ▼, ◄ : Pan the magnified image in camera mode
(5) WHITE : Lock/unlock auto white balance
BALANCE
(6) ZOOM : Zoom in and zoom out the image in
camera mode
Remote control
(1) INPUT : Switch to output signal from TLPC001
document camera or computer in
(2) GAIN : Adjust the gain value of the image (±16)
(3) ▲, ►, ▼, ◄ : Pan the magnified image in camera mode
(4) ZOOM : Zoom in and zoom out the image in
camera mode
(1)
(3)
(2) (4)
Remote control
11

♦ Zoom operation

TLPC001 uses 3Mega CMOS camera with the maximum pixel of H2048
x V1536 (QXGA).
[Sensor zoom]
•
Sensor zoom outputs the image up to H1024-pixel x V 768-pixel
which only uses a portion of the signal. The image is still in its original
pixel data and does not affect the image quality.
[Digital zoom]
•
Digital zoom interpolates the pixels to enlarge the image. High
expansion makes the image blurry.
[Zoom operation]
•
Zooming process changes automatically as follows:
100% Normal
110%-190% Digital zoom
200% Sensor zoom
210%-400% Sensor zoom (200%) + digital zoom
When the "zoom +" key is pressed for about 3 sec, it automatically
•
zoom in the image and stops up 200%. To continue magnification up
to 400%, release and press "zoom +" key again.
When switching from digital to sensor zoom (between 190% and
•
200%), the image would normally disappear for a moment to change
the processing mode.

LED indicator

(1)
Name Function
(1) CAMERA : Light up in camera mode
(2) ON/ STANDBY - Blink when the unit is initializing
- Turn orange when the unit is in standby mode
- Turn green when the unit is on and ready to use
(3) LOCK : Light up when the AWB feature is locked
(2)
(3)
12