Bunn SPEED BREW GRX Manuel Du Propriétaire page 12

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CLEANING THE SPRAYHEAD
Cleaning the sprayhead tube removes deposits formed
by natural mineral content in your water. The more
mineral content in your water, the more you should clean.
A good rule of thumb is to clean it every 3 months.
If you have very hard water, then twice a month may
be necessary.
You will need: a toothpick, dish soap, and a soft cloth.
• Press the tank power switch to the OFF position, unplug
the coffee maker and allow it to cool for at least 2 hours.
• Remove the funnel and unscrew the sprayhead,
loosening with your fingertips.
• Reinsert funnel in machine.
• Pour a carafe of fresh water into the coffee maker.
Keep lid open.
• Place the empty carafe under the funnel and close the
lid. Water will flow into the carafe.
• Check the sprayhead holes and clear any deposits
with the toothpick.
12
• Clean the sprayhead with a cloth and dish soap.
Rinse with water.
• Empty the water from the carafe and replace the empty
carafe under the funnel.
• Remove the brew funnel and reinstall the sprayhead.
Reinsert the brew funnel.
• Plug in the coffee maker. Press the tank power switch
to the ON position.
• Wait 15 minutes for the water in the tank to reach
brew temperature.
• Your machine is again ready for brewing.
*NOTE:
For a replacement sprayhead, call customer service at
1-800-352-2866 (USA) or 1-800-263-2256 (Canada).

Publicité

Table des Matières
loading

Table des Matières