Maintenance Instructions; Troubleshooting Guide; Warranty Information - BriskHeat TSREH Mode D'emploi

TSREH Silicone Rubber Enclosure Heaters

MAINTENANCE INSTRUCTIONS

Anyone who reads and understands these
instructions is qualified to maintain this heater.
Maintenance:

All maintenance should be performed after heater has cooled to room temperature and
with the electricity disconnected.

This product should be inspected prior to being installed and at least every 3 months
during use.

Dirt, oil, grease or other foreign matter can be removed with a damp rag and mild
household cleaners.

Do not attempt to repair a damaged heater.
Inspection:

Inspection should be performed after the heater has cooled to room temperature and
with the electricity disconnected.

The heater should be free of any cuts, cracks, or punctures.

The power leads should not have any visible breaks in their insulation

The heater should be free of any build-up of dirt, oil, grease, or other foreign matter.
Storage:

This product should be stored indoors.
Disposal:

This product does not contain any hazardous substances and may be discarded with
domestic waste.
®
© BriskHeat Corporation. All rights reserved
.
7
TSREH Silicone Rubber Enclosure Heaters

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting BriskHeat
most commonly asked questions. If you are unable to identify the problem or need
additional assistance, please contact your local distributor / representative or BriskHeat at
1-800-848-7673, 614-294-3376, or bhtsales1@briskheat.com.
PROBLEM SOLUTION(S)
Heater does not warm up Verify heater is connected to proper voltage.
Check to see if there is a resistance reading (not an open
circuit) in heater using an ohm meter.
Circuit breaker is tripping Validate that the circuit breaker is capable of handling the
amp requirement of heater. The identification label
located on the power cord displays the heater's
amperage requirement.
Examine heater and cord for any damage.
Check to see if there is a resistance reading between
power leads and the ground lead.

WARRANTY INFORMATION

®
BriskHeat warrants to the original purchaser of this product for the period of eighteen (18)
months from date of shipment or twelve (12) months from date of installation, whichever
®
comes first. BriskHeat 's obligation and the exclusive remedy under this warranty shall be
limited to the repair or replacement, at BriskHeat
which may prove defective under prescribed use and service following BriskHeat
®
examination, is determined by BriskHeat
warranty can be found online at www.briskheat.com or by contacting us at
1-800-848-7673 (toll free, U.S. / Canada) or 1-614-294-3376 (Worldwide).
Corporate Headquarters:
4800 Hilton Corporate Dr.
Columbus, OH 43232, U.S.A.
Toll Free: 800-848-7673
Phone: 614-294-3376
Fax: 614-294-3807
Email: bhtsales1@briskheat.com
®
© BriskHeat Corporation. All rights reserved
®
. This guide is designed to answer the
®
's option, of any parts of the product
®
's
to be defective. The complete details of the
Europe:
P.O. Box 420124
44275 Dortmund, Germany
.
8