Télécharger Imprimer la page

Urmet FDi EASY DOOR Manuel page 12

Recepteur

Publicité

Les langues disponibles

Les langues disponibles

Reset the factory settings:
Push the S1 switch to On and press the RTE button until you hear a sequence of increasingly quick
beeps indicating the erasure of the memory. A last beep will confirm the resetting of the receiver.
Push S1 back to Off.
Note : the master remote controls are not removed.
Easy Door receiver offers two ways to manage keys. The local mode does not require any extra
equipment, but has some limits. The remote mode through www.easydoorcontroller.com web
software allows to manage more doors/ gates per site, to setup the controllers and download events.
SPECIFIC PROGRAMMING FOR THE STANDALONE MODE :
The top left button of the remote control operates relay 1 and the top right relay 2 when the S6
dipswitch is Off.
When it is On, the down left button operates relay 1 and down right button relay 2.
The receiver manages two types of remote controls: user or master. A user remote control opens the
gate and the master key is able to add new remotes.
Basic programming:
Add master remote controls (10 max) :
Move the dipswitch n°1 to On. The red programming led turns on and you can hear 3 beeps.
Press the push button 1 of the master remote control and a short beep indicate its recording. Each
time you present a new key, the receiver acknowledges with a short beep.
After programming the last remote control, move switch 1 back to Off (Expl). A last beep will confirm
you have come out of the programming mode.
Add user remote controls (1500 max):
Press the first push button of a master remote control for 5 seconds until the light is red and the
receiver generates 3 beeps.
Press the first push button of the remotes controls you want to add. For each new remote control, the
buzzer will generate a beep.
After you pressed the last user remote control, press the master one shortly to leave the programming
mode.
The led turns off and a last beep will confirm you have come out of the programming mode.
Delete user remote controls:
Press the first push button of a master remote control for 5 seconds until the light is red and the
receiver generates 3 beeps.
Press for 5 secs the first push button of the remote control you want to remove. For each removed
remote control, the buzzer will generate a beep.
After deleting the last remote control, press the master one shortly to leave the programming mode.
The led turns off and a last beep will confirm you have come out of the programming mode.
Delete all resident keys:
Move the dipswitch N°1 to ON, then press and hold the door 1 exit push button for 5 secs until the
controller led flashes quickly (3 times / sec). Move back the switch. All user remote controls are now
deleted.
Delete all master remote controls:
Turn off the power supply. Move the dipswitch n°1 to On then turn on the power supply.
Switch the dipswitch N°1 back to Off. A last beep will confirm you have come out of the programming
mode.
DOC.50-001-450.C
FDI MATELEC SA Route de St Symphorien 85130 Les landes Génusson - France
www.fdimatelec.com
12

Publicité

loading